cancel
Showing results for 
Search instead for 
Did you mean: 
rgray
Mission Specialist
Mission Specialist
  • 3,670 Views

Homelab setups

Jump to solution

Screenshot from 2019-04-02 08-38-28.png

How do I react to this output from lab launch-cli setup?
Context: Procedure 1.3 -- Guided Exercise: Launching an Instance Using the CLI

1 Solution

Accepted Solutions
rgray
Mission Specialist
Mission Specialist
  • 3,573 Views

Learned the issue and it is caused by my inexpereince in these classes. It is necessary to wait until all servers are ready before starting any lab command.

Readiness is determined by

(1)  All lab servers have completed RHEL installed. Look for "STARTED" (see below.)

AND
(2) All servers have completed OpenStack configuration.

      (a) should have happened by waiting a few minutes after (1) above

      or (to be absolutely certain)
      (b) Utlize "Open Console" for each server, to validate stdout messages are not still scrolling,  and a login prompt is available.


CL110 Lab 1.png

View solution in original post

7 Replies
Amel
Mission Specialist
Mission Specialist
  • 3,648 Views

You might want to specify which course this is.

 

rgray
Mission Specialist
Mission Specialist
  • 3,636 Views

Yes, of course (no pun intended.) I actually had the course info in the title, but this discussion tool replaced it with "Homelab setups."

CL110 Red Hat OpenStack Administration I: Core Operations for Cloud Operators

Lisenet
Starfighter Starfighter
Starfighter
  • 3,614 Views

Just a wild guess, but did you complete the previous procedures? Perhaps this particular (Procedure 1.3) setup depends on the outcome of the previous one (e.g. Procedure 1.2).

rgray
Mission Specialist
Mission Specialist
  • 3,601 Views

Right you are Lisenet, thank you! I'm starting over now.

0 Kudos
rgray
Mission Specialist
Mission Specialist
  • 3,574 Views

Learned the issue and it is caused by my inexpereince in these classes. It is necessary to wait until all servers are ready before starting any lab command.

Readiness is determined by

(1)  All lab servers have completed RHEL installed. Look for "STARTED" (see below.)

AND
(2) All servers have completed OpenStack configuration.

      (a) should have happened by waiting a few minutes after (1) above

      or (to be absolutely certain)
      (b) Utlize "Open Console" for each server, to validate stdout messages are not still scrolling,  and a login prompt is available.


CL110 Lab 1.png

  • 3,538 Views

Hello,

I'm trying to do the 1st Lab from "Red Hat JBoss Application Administration II / 1. What's New in JBoss EAP 7? / Lab: What's New in JBoss EAP 7?" and tried the 2nd Lab, too from "2. Migrating to JBoss EAP 7 / Lab: Migrating to JBoss EAP 7", but the setup command couldn't be found, also under /opt/ is only /rh/, nor jboss-eap-7.0 or domain, neither /home/student/JB348/labs/

All the lab servers are up and accessible.

Please, assist.

 

Regards.

Couldn't initiate Lab setupCouldn't initiate Lab setup

  • 3,501 Views

Now it got recovered (reboted the servers yesterday), thanks.

 

Capture.JPG

Join the discussion
You must log in to join this conversation.