Homelab setups

[rgray]

How do I react to this output from lab launch-cli setup?
Context: Procedure 1.3 -- Guided Exercise: Launching an Instance Using the CLI

[Amel]

You might want to specify which course this is.

[rgray]

Yes, of course (no pun intended.) I actually had the course info in the title, but this discussion tool replaced it with "Homelab setups."

CL110 Red Hat OpenStack Administration I: Core Operations for Cloud Operators

[Lisenet]

Just a wild guess, but did you complete the previous procedures? Perhaps this particular (Procedure 1.3) setup depends on the outcome of the previous one (e.g. Procedure 1.2).

[rgray]

Right you are Lisenet, thank you! I'm starting over now.

[rgray · Accepted solution]

Learned the issue and it is caused by my inexpereince in these classes. It is necessary to wait until all servers are ready before starting any lab command.

Readiness is determined by

(1)  All lab servers have completed RHEL installed. Look for "STARTED" (see below.)

AND
(2) All servers have completed OpenStack configuration.

      (a) should have happened by waiting a few minutes after (1) above

      or (to be absolutely certain)
      (b) Utlize "Open Console" for each server, to validate stdout messages are not still scrolling,  and a login prompt is available.

[ValeriuCraciun]

Hello,

I'm trying to do the 1st Lab from "Red Hat JBoss Application Administration II / 1. What's New in JBoss EAP 7? / Lab: What's New in JBoss EAP 7?" and tried the 2nd Lab, too from "2. Migrating to JBoss EAP 7 / Lab: Migrating to JBoss EAP 7", but the setup command couldn't be found, also under /opt/ is only /rh/, nor jboss-eap-7.0 or domain, neither /home/student/JB348/labs/

All the lab servers are up and accessible.

Please, assist.

Regards.

Couldn't initiate Lab setup

[ValeriuCraciun]

Now it got recovered (reboted the servers yesterday), thanks.