
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 2,915 Views
I cannot start the lab with command: lab start software-rpm.
I get this error:
ModuleNotFoundError: No module named 'rhcsa-classroom'
Script software-rpm not in course library rhcsa-classroom
Anyone else see this?
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 3,889 Views
Hello @AbeHiero !
Thanks for reaching out !
I am not able to reproduce this error in RH124 labs :
Please verify if all the VMs are up and running in your lab environment or better rebuild a fresh lab environment and then re-run this lab script.
If you are still facing the issue, I suggest you to raise a support case and our backend team will help you in the same.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 3,870 Views
Rebuilding the lab environment worked. Thank you

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 3,890 Views
Hello @AbeHiero !
Thanks for reaching out !
I am not able to reproduce this error in RH124 labs :
Please verify if all the VMs are up and running in your lab environment or better rebuild a fresh lab environment and then re-run this lab script.
If you are still facing the issue, I suggest you to raise a support case and our backend team will help you in the same.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 3,871 Views
Rebuilding the lab environment worked. Thank you

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 3,867 Views
Awsome @AbeHiero !

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 1,768 Views
On the workstation machine, open two terminal windows side by side. In this section, these terminals are referred to as left and right. In each terminal, use the ssh command to log in to the servera machine as the student user.
[student@workstation ~]$ ssh student@servera
[student@servera ~]$

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 637 Views
I am getting the below error whenever starting the lab with command: lab start software-rpm.
Error -

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 635 Views
-Command did not exit with the expected code.
- Expected : 0, Received : 1

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- 613 Views
@SaumyaSaxena_1 try to re-run the lab start script or if it did not help try deleting your existing lab env and recreate a fresh new one.