This thread is dedicated to connect you with Red Hat subject matter experts who can help answer your questions regarding Red Hat remote exams. Please see the following resources for Red Hat Remote Exams below:
For questions on scheduling or redeeming your exams, please use the Red Hat Certification team comment form here.
**Our subject matters experts in the Red Hat Learning Community will not be assisting with tasks related to scheduling exams.
awesome thank you .
My system integrated microphone and speaker is not working with LiveUSB (exam OS or rhrexboot.iso) only. It is working good with Windows and Fedora as well. Could you please fix this driver issue asap in the image.
Hi Rakesh,
You get this issue when your integrated mic/speakers are not compatible with exam iso. You May try connecting an External camera and verify the mic settings by booting from usb stick >> go to Settings >> Sound>> input devices and test the mic displayed and the volume. You may also try connecting a wired headphones and place it on desk.
I have a question. The request is to have two usb ports, one for usb drive and the other for the webcam. But when the live start, the usb drive must be detached. Then, can I connect a usb mouse in place of usb drive? I have a PC with two usb port. Thanks.
I've been able to replace the USB stick with my USB keyboard, so this might work for your mouse, too. But I was using a laptop - so there were fallback input devices that the live system could recognize while starting up.
Best you can do is to simply try it out - you're supposed to test-run the exam environment several times before the exam, anyway.
Good luck!
Thanks. Yes I try the configuration:
1. usb disk and external camera plugged in
2. after SO start, replace usb disk with mouse
and it's OK.
I hope that the proctor confirm this configurations.
network is showing as not enables when I boot into live environment.I have link to my route via wired connection.I see its enabled but every time I try to finish booting to the live env it says network is not enabled.
Hi all, another question. My external camera have autofocus but the identification document is not readable, when I put it near the camera.
Then I try with both internal and external camera activated, because the autofocus of the internal camera working fine. Can I keep both active and use the internal for focus on the identification document and external for show the environment? Thanks.
That should be OK - I've used a similar setup in the past and hadn't had any issues or comments from surprised proctors.
Red Hat
Learning Community
A collaborative learning environment, enabling open source skill development.