EX240 - lab install principles always fails

[nshende]

I am getting following error after starting labs. As mentioned in student guide I have tried running it after 30-45 mins. But still getting the same error.

[Wasim_Raja]

@nshende Thank you for reaching out.

Can you please make sure the openshift cluster is up and then try.

To check the cluster status follow the below steps.

1. ssh lab@utility

2. ./wait.sh

The step 2 script will give the status of the cluster, once you see everything as up then please try the lab script it again it should work.

Let us know how it goes.

[nshende]

Hi Wasim, 
 I tried above steps and wait.sh script never seems to go beyond waiting for Authentication.

Attached screenshot for your reference.

I had the script running for about an hour.

[Wasim_Raja]

@nshende Please open a support ticket using the support tab at the ROL hompage the concerned team will assist you.

[elalance]

I have the exact same issue, 

Any idea what support did.  I 've open a support case but waiting.

[Chetan_Tiwary_]

@elalance what is the uptime showing in the workstation ?

[elalance]

I just restarted now is 16 minutes. I launched this morning, and the problem persisted for more than three hours.

[Chetan_Tiwary_]

@elalance what about the OCP cluster , was it ready ? You can check it by :

1. [student@workstation]$ ssh lab@utility

2. ./wait.sh

wait for it to finish before you can run any lab script.

better delete your existing lab and retry this.

[elalance · Accepted solution]

ok I delete the lab reinstall and run this 

1. [student@workstation]$ ssh lab@utility

2. ./wait.sh

And now working fine

[Chetan_Tiwary_]

@elalance Thanks for confirmation!