cancel
Showing results for 
Search instead for 
Did you mean: 
nshende
Mission Specialist
Mission Specialist
  • 1,280 Views

EX240 - lab install principles always fails

Jump to solution

I am getting following error after starting labs. As mentioned in student guide I have tried running it after 30-45 mins. But still getting the same error.DO240FailedLab.png

1 Solution

Accepted Solutions
elalance
Cadet
Cadet
  • 295 Views

ok I delete the lab reinstall and run this 

1. [student@workstation]$ ssh lab@utility

2. ./wait.sh

And now working fine

View solution in original post

9 Replies
Wasim_Raja
Moderator
Moderator
  • 1,247 Views

@nshende Thank you for reaching out.

Can you please make sure the openshift cluster is up and then try.

To check the cluster status follow the below steps.

1. ssh lab@utility

2. ./wait.sh

The step 2 script will give the status of the cluster, once you see everything as up then please try the lab script it again it should work.

Let us know how it goes.

0 Kudos
nshende
Mission Specialist
Mission Specialist
  • 1,235 Views

Hi Wasim, 
 I tried above steps and wait.sh script never seems to go beyond waiting for Authentication.

Attached screenshot for your reference.DO240labWaiting.png

 

I had the script running for about an hour.

Wasim_Raja
Moderator
Moderator
  • 1,224 Views

@nshende Please open a support ticket using the support tab at the ROL hompage the concerned team will assist you.

0 Kudos
elalance
Cadet
Cadet
  • 405 Views

I have the exact same issue, 
do240.1.jpg
Any idea what support did.  I 've open a support case but waiting.

Chetan_Tiwary_
Community Manager
Community Manager
  • 404 Views

@elalance what is the uptime showing in the workstation ?

elalance
Cadet
Cadet
  • 403 Views

I just restarted now is 16 minutes. I launched this morning, and the problem persisted for more than three hours.

Chetan_Tiwary_
Community Manager
Community Manager
  • 402 Views

@elalance what about the OCP cluster , was it ready ? You can check it by :

1. [student@workstation]$ ssh lab@utility

2. ./wait.sh

wait for it to finish before you can run any lab script.

better delete your existing lab and retry this.

elalance
Cadet
Cadet
  • 296 Views

ok I delete the lab reinstall and run this 

1. [student@workstation]$ ssh lab@utility

2. ./wait.sh

And now working fine

Chetan_Tiwary_
Community Manager
Community Manager
  • 285 Views

@elalance Thanks for confirmation!

0 Kudos
Join the discussion
You must log in to join this conversation.